Latest EMC GUI

on 2001-12-04 16:55:28 UTC

Anyone using Ray's latest GUI Miniex? I can't seem to figure out which
file to look at so I can change the startup default jog feed rate that
shows up on the screen. It's set to 1 inch a min every time I run it.
Also I would like to change the axis numbers to X Y Z rather than 0 1
2 3.

Frank

Discussion Thread

shymu@b... 2001-12-04 16:55:28 UTC Latest EMC GUI Ray 2001-12-04 20:11:38 UTC Re: Latest EMC GUI johnbranlund 2001-12-04 23:29:55 UTC Re: Latest EMC GUI Ray 2001-12-05 06:33:08 UTC Re: Latest EMC GUI M Doogan 2001-12-05 07:34:20 UTC Re: [CAD_CAM_EDM_DRO] Re: Latest EMC GUI