matsushita stepper specs ?
Posted by
dave_ace_me
on 2001-12-17 11:02:46 UTC
Hi,
I got the timing belt and gears worked out for automating my drill
press, and have a stepper motor from the copier I am using for parts.
The stepper is Matsushita model GLQ-6DB071A and has a 7:1 ratio gear
reduction as part of the unit.
There is also an intgrated circutit board, lookes like a mirco
controller with resonator, caps and all.
the stepper is 24 VDC 1.4 A so it should be strong enough.
The connector on the board has 4 pins,
GND 24V P/S and LD
I can't find ANY data on Matsushita steppers on the web, just
circular references of Panasonic.
Does anybody have any ideas on either how/where to find motor data or
maybe how to wire this puppy ?
TIA,
Dave
I got the timing belt and gears worked out for automating my drill
press, and have a stepper motor from the copier I am using for parts.
The stepper is Matsushita model GLQ-6DB071A and has a 7:1 ratio gear
reduction as part of the unit.
There is also an intgrated circutit board, lookes like a mirco
controller with resonator, caps and all.
the stepper is 24 VDC 1.4 A so it should be strong enough.
The connector on the board has 4 pins,
GND 24V P/S and LD
I can't find ANY data on Matsushita steppers on the web, just
circular references of Panasonic.
Does anybody have any ideas on either how/where to find motor data or
maybe how to wire this puppy ?
TIA,
Dave
Discussion Thread
dave_ace_me
2001-12-17 11:02:46 UTC
matsushita stepper specs ?
dave_ace_me
2001-12-20 09:38:28 UTC
Re: matsushita stepper specs ?
Jon Elson
2001-12-20 11:21:44 UTC
Re: [CAD_CAM_EDM_DRO] Re: matsushita stepper specs ?
dave_ace_me
2001-12-21 11:59:24 UTC
Re: matsushita stepper specs ?