EMC and StepperWorld
Posted by
jlm_1951
on 2001-12-18 17:01:06 UTC
Hi,
Has anyone been able to set up EMC to work with the StepperWorld
SP3 series of controller? So far I've only been able to get one
axis to respond. I think it's because the SW controller needs
three port pins set to "enable" the motors and EMC doesn't use those
pins.
Thanks in advance,
Joel
Has anyone been able to set up EMC to work with the StepperWorld
SP3 series of controller? So far I've only been able to get one
axis to respond. I think it's because the SW controller needs
three port pins set to "enable" the motors and EMC doesn't use those
pins.
Thanks in advance,
Joel