Re: "Best Practice" Recommendations - Reply to Jon Elson
Posted by
glee@i...
on 2001-12-24 01:52:09 UTC
Jon, it sounds like I was running my 1/8" end mill WAY too slow (2500 RPM)
to cut aluminim.
I think the Sherline tops out at something like 3500RPM.
I looks like I plan to use such small cutters that I should go and purchase
the 10,000 RPM Spindle upgrade.
Thank you to you and the rest who replied re: my other questions.
-Eric Mack
to cut aluminim.
I think the Sherline tops out at something like 3500RPM.
I looks like I plan to use such small cutters that I should go and purchase
the 10,000 RPM Spindle upgrade.
Thank you to you and the rest who replied re: my other questions.
-Eric Mack
Discussion Thread
glee@i...
2001-12-24 01:52:09 UTC
Re: "Best Practice" Recommendations - Reply to Jon Elson
ballendo
2001-12-24 07:20:47 UTC
Re: "Best Practice" Recommendations - Reply to Jon Elson
Jon Elson
2001-12-24 23:14:12 UTC
Re: [CAD_CAM_EDM_DRO] Re: "Best Practice" Recommendations - Reply to Jon Elson