Re: [CAD_CAM_EDM_DRO] Help, I dropped a servo motor and the magnets seperated.......
Posted by
Ed Koffeman
on 2001-12-28 11:57:03 UTC
Yes. JBWeld works well. In general, epoxy works for glueing magnets.
If it won't stay in place by its own magnetism, "C" clamp it with some wood or something else soft protecting the magnet.
If you don't know which magnet went where (look for small pices left attached) then if you mix them up the motor's polarity might be
reversed and you'll need to flip the wiring as well (watch out because it won't close the feedback loop when reversed!).
Ed Koffeman
If it won't stay in place by its own magnetism, "C" clamp it with some wood or something else soft protecting the magnet.
If you don't know which magnet went where (look for small pices left attached) then if you mix them up the motor's polarity might be
reversed and you'll need to flip the wiring as well (watch out because it won't close the feedback loop when reversed!).
Ed Koffeman
----- Original Message -----
From: "mueller914" <mmueller@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, December 28, 2001 1:46 PM
Subject: [CAD_CAM_EDM_DRO] Help, I dropped a servo motor and the magnets seperated.......
> I dropped a servo motor and the magnets came unglued from the case.
> Can I reglue these back to the case? The motors are small 430oz
> Litton(?) motors sold by Camtronics.
>
> Thanks,
>
> Mike
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
Discussion Thread
mueller914
2001-12-28 11:46:49 UTC
Help, I dropped a servo motor and the magnets seperated.......
Ed Koffeman
2001-12-28 11:57:03 UTC
Re: [CAD_CAM_EDM_DRO] Help, I dropped a servo motor and the magnets seperated.......
mueller914
2001-12-28 12:02:01 UTC
Re: Help, I dropped a servo motor and the magnets seperated.......