Possible deal on G320 drives
Posted by
Tim
on 2002-01-04 11:29:11 UTC
I am trying to decide whether this would be of interest to the group or
not and figures I would run it up the flag pole.
I have the opportunity to get a limited number of the original version
Gecko G320 step and direction servo drives on a close-out basis that I
would be able to sell for $75 each or 3 for $215 plus appropriate
shipping and insurance. These would be offered just like the close out
G201 drives I am selling meaning they are without covers and have no
factory warrantee or support. They are factory tested to be in perfect
condition, but are close-outs due to being the previous model.
Following are the features you that these drive do not have:
Encoder signal filtering (you can add a very simple chip that has the
connection diagram in the files section of the group that will pretty
much give you the same filtering for about $1 per drive)
Dither reduction
Modular terminals
There are many many people using this exact revision of the drive very
successfully and they will spin your motors just fine. I used this
version for quite a while and was very satisfied with the performance
and features and still use them on my Shoptask.
If any of you are interested in these let me know and if there is enough
interest I will go ahead and make them available. Also if anyone is
interested in the original revision G201 I still have them for same.
Contact me off list at timg@...
Tim
[Denver, CO]
not and figures I would run it up the flag pole.
I have the opportunity to get a limited number of the original version
Gecko G320 step and direction servo drives on a close-out basis that I
would be able to sell for $75 each or 3 for $215 plus appropriate
shipping and insurance. These would be offered just like the close out
G201 drives I am selling meaning they are without covers and have no
factory warrantee or support. They are factory tested to be in perfect
condition, but are close-outs due to being the previous model.
Following are the features you that these drive do not have:
Encoder signal filtering (you can add a very simple chip that has the
connection diagram in the files section of the group that will pretty
much give you the same filtering for about $1 per drive)
Dither reduction
Modular terminals
There are many many people using this exact revision of the drive very
successfully and they will spin your motors just fine. I used this
version for quite a while and was very satisfied with the performance
and features and still use them on my Shoptask.
If any of you are interested in these let me know and if there is enough
interest I will go ahead and make them available. Also if anyone is
interested in the original revision G201 I still have them for same.
Contact me off list at timg@...
Tim
[Denver, CO]