Large Router, Plasma, anyone ??

Got to start having a sort out.
I have two ballscrews that would suit a 8' x 4' sheet router or
plasma cutter.
These are ex - laser cutting machine screws and are Thompson
precision ground models, top of the range. The long X axis cost over
3,000 new.
Two X and Y axis DC servo motors SEM models and high power 140v, 4.5
Nm. Complete with tacho but no encoder.
Baldor servo amps to suit the two motors with power supply. This came
off the same machine and I have the Baldor book with it.
Power transformer for the motors and sevo amps. Big beast 440v 3
phase input.
Short of the encoders there is enough her to get a complete two axis
setup running, just add your favorite controller.
Also have two Seimens DC servo's with resolvers. 170v 2.2 Nm.

Open to any reasonable offer but obviously has to be UK side due to
weight / size restrictions.

John S.
Located Nottingham, England.