Re: run two geckos from same pins
Posted by
epatsellis
on 2002-01-11 11:23:43 UTC
FWIW,
Stock Drive Products carries 1/5" pitch belts to 118" centers, so if
so inclined, timing belts are still an option
erie patsellis
: [CAD_CAM_EDM_DRO] run two geckos from same pins
Stock Drive Products carries 1/5" pitch belts to 118" centers, so if
so inclined, timing belts are still an option
erie patsellis
: [CAD_CAM_EDM_DRO] run two geckos from same pins
>
>
> > Doug Fortune wrote:
> > >
> > > Back to your XXYZ cnc router, it would be great to
> > > to run a timing belt across both X axes (even though
> > > you have 2 motors with 1 or 2 controllers), just to
> > > keep them both honest (because steppers are <usually>
> > > open loop systems).
> > >
Discussion Thread
carlcnc
2002-01-05 19:36:20 UTC
run two geckos from same pins
Doug Fortune
2002-01-05 21:15:54 UTC
Re: [CAD_CAM_EDM_DRO] run two geckos from same pins
Doug Fortune
2002-01-05 21:26:04 UTC
Re: [CAD_CAM_EDM_DRO] run two geckos from same pins
Bob Campbell
2002-01-06 10:57:23 UTC
Re: [CAD_CAM_EDM_DRO] run two geckos from same pins
epatsellis
2002-01-11 11:23:43 UTC
Re: run two geckos from same pins
JanRwl@A...
2002-01-11 13:49:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: run two geckos from same pins
JanRwl@A...
2002-01-11 14:54:42 UTC
Re: [CAD_CAM_EDM_DRO] Re: run two geckos from same pins
ballendo
2002-01-11 19:32:18 UTC
xl vs. HTD (again ) was Re: run two geckos from same pins