run two geckos from same pins
Posted by
carlcnc
on 2002-01-05 19:36:20 UTC
I am sure someone is doing this already.
i am building a table with twin screw drive on X.
Will I have to do anything special to facilitate running two
gecko210s with the same step and dir. pins from parallel port?
I know it would be ideal to have the screws connected with a timing
belt,but at 48" center to center I expect it would take at least "H"
series to get a standard length.
thanks
Carl
i am building a table with twin screw drive on X.
Will I have to do anything special to facilitate running two
gecko210s with the same step and dir. pins from parallel port?
I know it would be ideal to have the screws connected with a timing
belt,but at 48" center to center I expect it would take at least "H"
series to get a standard length.
thanks
Carl
Discussion Thread
carlcnc
2002-01-05 19:36:20 UTC
run two geckos from same pins
Doug Fortune
2002-01-05 21:15:54 UTC
Re: [CAD_CAM_EDM_DRO] run two geckos from same pins
Doug Fortune
2002-01-05 21:26:04 UTC
Re: [CAD_CAM_EDM_DRO] run two geckos from same pins
Bob Campbell
2002-01-06 10:57:23 UTC
Re: [CAD_CAM_EDM_DRO] run two geckos from same pins
epatsellis
2002-01-11 11:23:43 UTC
Re: run two geckos from same pins
JanRwl@A...
2002-01-11 13:49:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: run two geckos from same pins
JanRwl@A...
2002-01-11 14:54:42 UTC
Re: [CAD_CAM_EDM_DRO] Re: run two geckos from same pins
ballendo
2002-01-11 19:32:18 UTC
xl vs. HTD (again ) was Re: run two geckos from same pins