New poll for CAD_CAM_EDM_DRO
Posted by
CAD_CAM_EDM_DRO@y...
on 2002-01-21 15:39:51 UTC
Enter your vote today! A new poll has been created for the
CAD_CAM_EDM_DRO group:
Do you want CNC procedures such as
tapping, boring, threading, allowed on
the list?
Be sure to vote, as this will be the
controlling factor if it is allowed, I
am leaning towards allowing it, but
want the lists opinion.
BE SURE TO VOTE YOUR PREFERANCE......
bill
o Yes
o No
To vote, please visit the following web page:
http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/polls
Note: Please do not reply to this message. Poll votes are
not collected via email. To vote, you must go to the Yahoo! Groups
web site listed above.
Thanks!
CAD_CAM_EDM_DRO group:
Do you want CNC procedures such as
tapping, boring, threading, allowed on
the list?
Be sure to vote, as this will be the
controlling factor if it is allowed, I
am leaning towards allowing it, but
want the lists opinion.
BE SURE TO VOTE YOUR PREFERANCE......
bill
o Yes
o No
To vote, please visit the following web page:
http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/polls
Note: Please do not reply to this message. Poll votes are
not collected via email. To vote, you must go to the Yahoo! Groups
web site listed above.
Thanks!
Discussion Thread
CAD_CAM_EDM_DRO@e...
2001-01-14 13:24:22 UTC
New poll for CAD_CAM_EDM_DRO
CAD_CAM_EDM_DRO@y...
2002-01-21 15:39:51 UTC
New poll for CAD_CAM_EDM_DRO
Fitch R. Williams
2002-01-21 16:58:52 UTC
Re: [CAD_CAM_EDM_DRO] New poll for CAD_CAM_EDM_DRO
Bill Vance
2002-01-21 17:42:38 UTC
Re: [CAD_CAM_EDM_DRO] New poll for CAD_CAM_EDM_DRO
Garry & Maxine Foster
2002-01-21 17:58:48 UTC
Re: [CAD_CAM_EDM_DRO] New poll for CAD_CAM_EDM_DRO