Re: [CAD_CAM_EDM_DRO] New poll for CAD_CAM_EDM_DRO

On 21 Jan 2002 23:39:48 -0000, CAD_CAM_EDM_DRO@yahoogroups.com wrote:

The Yahoo SW won't let me vote. It says I'm not a member of this group.

If I could vote, I'd vote Y E S ! !

Fitch

>
>Enter your vote today! A new poll has been created for the
>CAD_CAM_EDM_DRO group:
>
>Do you want CNC procedures such as
>tapping, boring, threading, allowed on
>the list?
>Be sure to vote, as this will be the
>controlling factor if it is allowed, I
>am leaning towards allowing it, but
>want the lists opinion.
>BE SURE TO VOTE YOUR PREFERANCE......
>bill
>
> o Yes
> o No
>
>
>To vote, please visit the following web page:
>
>http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/polls
>
>Note: Please do not reply to this message. Poll votes are
>not collected via email. To vote, you must go to the Yahoo! Groups
>web site listed above.
>
>Thanks!
>
>
>
>
>
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>