CNC Retro kit help
Posted by
kdoney_63021
on 2002-01-28 08:58:27 UTC
I finally made a decision and purchased a 9X42 Enco mill and 13X40
Enco lathe, thanks to Dan Mauch. Please, no comments about Enco, I
paid my money and am taking my chances. I now need a CNC kit for one
or both of them. This kit does not need to include a controller since
I am going to use EMC. I will need everything else from there to the
machine. Driver, cable, pulley, etc.. I would like an easy kit but
precise results. Any suggestions? I can do easy installation
procedures when guided step by step like drill a hole, tap the hole,
etc.. I am a reasonably good tig welder but mainly deal with
computers.
Enco lathe, thanks to Dan Mauch. Please, no comments about Enco, I
paid my money and am taking my chances. I now need a CNC kit for one
or both of them. This kit does not need to include a controller since
I am going to use EMC. I will need everything else from there to the
machine. Driver, cable, pulley, etc.. I would like an easy kit but
precise results. Any suggestions? I can do easy installation
procedures when guided step by step like drill a hole, tap the hole,
etc.. I am a reasonably good tig welder but mainly deal with
computers.