Re: Need Stepper Help!

I have some motors like these only they are KP56QM2-001. The are 5.2
volts and 1.4 amps. I found a page that was selling these motor and
they rated them at , 85 OZ-IN 400 STEPS/REV. It also says (6 wire CT
windings 3.5 ohm - 0 - 3.5 ohm
maximun current: CENTER TAPPED - 1.5A , BIPOLAR, FULL WINDING - 1.0A


--


- In CAD_CAM_EDM_DRO@y..., "craigl452000" <craigl@s...> wrote:

> --- In CAD_CAM_EDM_DRO@y..., "mariss92705" <mariss92705@y...> wrote:
> Thank you very much i could not find any info at all
>
> > Craig,
> >
> > Get out your ohm meter and place one meter lead to anyone of the
> > motor leads. Find the two other motor wires that will have
> continuity.
> >
> > From these three motor wires, find the two that measure the

highest

> > resistance (10 ohms in your case). Mark these wires as "winding

end-

> > wires". Mark the remaining one as "center-tap". Repeat above for
> the
> > remaining three wires.
> >
> > 5V at 1A will be a single-stack size 23 motor with about 50 in-oz
> of
> > low speed torque.
> >
> > Mariss
> >
> >
> > --- In CAD_CAM_EDM_DRO@y..., "craigl452000" <craigl@s...> wrote:
> > > Need help to find info On a stepper motor form Japan Servo
> > > Type KP56hm2-008 5v 1 amp I cant find any info I look at
> > > Japan servo.com and I did many a search. Iam looking
> > > for help with the 6 wires and how much oz\in.
> > >
> > > TIA
> > > Craig