CAD CAM EDM DRO - Yahoo Group Archive

RE: BDI : Parallel Port Setup

Posted by Deon Styger
on 2002-02-05 04:40:48 UTC
Jon Elson wrote:

> First thing is to see what the BIOS finds on the motherboard. Go to
> the BIOS setup at boot time, and check in the peripherals section.
> You want the on-board port set for 378 to start with. It is
> often set to
> a different address by default.

I have checked the BIOS setting. It is set to 378.

> The parallel port used for stepper output is not subject to BIOS or
> standard drivers like parport.o, as it uses direct hardware
> instructions
> in the real-time section of EMC.

Paul Corner has mentioned the same thing in his reply. It seems that using a
PCI card is not an option with EMC. Thank you for your reply. I will remove
the card when I have time (tomorrow) and try again from there. I will also
re-check the .ini file to make sure that I haven't missed anything. I will
report back on my progress.

Deon Styger


---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.319 / Virus Database: 178 - Release Date: 28/01/2002

Discussion Thread

Deon Styger 2002-02-04 07:12:26 UTC BDI : Parallel Port Setup Jon Elson 2002-02-04 10:39:26 UTC Re: [CAD_CAM_EDM_DRO] BDI : Parallel Port Setup Paul 2002-02-04 12:36:49 UTC Re: [CAD_CAM_EDM_DRO] BDI : Parallel Port Setup Deon Styger 2002-02-05 04:40:46 UTC RE: BDI : Parallel Port Setup Deon Styger 2002-02-05 04:40:48 UTC RE: BDI : Parallel Port Setup Jon Elson 2002-02-05 06:04:21 UTC Re: [CAD_CAM_EDM_DRO] RE: BDI : Parallel Port Setup Paul 2002-02-05 13:00:39 UTC Re: [CAD_CAM_EDM_DRO] RE: BDI : Parallel Port Setup James (Jim) Buchanan 2002-02-05 14:55:12 UTC Re: [CAD_CAM_EDM_DRO] RE: BDI : Parallel Port Setup Deon Styger 2002-02-07 07:02:26 UTC RE: BDI : Parallel Port Setup