Re: [CAD_CAM_EDM_DRO] RE: BDI : Parallel Port Setup

Hi Deon

That is pretty much it - Two port addresses are specified, one for connection
to the stepper drives, the other for IO.

If you still have trouble, I'll email an ini file over that works on my
machine fitted with just one parallel port.

Regards, Paul.

Most of the seeds germinated thanks - Just a case of waiting for them to
flower ;))

On Tuesday 05 February 2002 12:43 pm, Deon Styger wrote:

> I will do this tomorrow and report back. Am I correct in assuming that if
> the port is found at a specific address, all I need to do is check that
> this address is specified in the .ini file? If I can then still not get out
> of e-stop I will have to check the other settings in my .ini file more
> carefully.