Re: bleeder resistors
Posted by
mariss92705
on 2002-02-13 18:29:02 UTC
Peter,
Why? Zero volts on a capacitor is not a reasonable goal. Take an
aluminum electrolytic capacitor, charge it up from a power supply.
Disconnect it and short it out with a piece of wire. Remove the short
and measure the voltage. Surprise! you will read a volt or more on
the cap. Short it again and you will get another spark. It's a little
something called dielectric absorption.
Generally a capacitor is considered discharged when there is 5% or
less of the original voltage left on it.
Mariss
Why? Zero volts on a capacitor is not a reasonable goal. Take an
aluminum electrolytic capacitor, charge it up from a power supply.
Disconnect it and short it out with a piece of wire. Remove the short
and measure the voltage. Surprise! you will read a volt or more on
the cap. Short it again and you will get another spark. It's a little
something called dielectric absorption.
Generally a capacitor is considered discharged when there is 5% or
less of the original voltage left on it.
Mariss
--- In CAD_CAM_EDM_DRO@y..., "cadcamcenter" <cadcamcenter@y...> wrote:
but am I asking/expecting too
> much for the voltage to fall off to ZERO after a reasonable >
> Peter
Discussion Thread
Alan Marconett KM6VV
2002-02-12 13:31:39 UTC
Re: bleeder resistors
tonyjeffree
2002-02-12 19:37:53 UTC
Re: bleeder resistors
cadcamcenter
2002-02-13 17:36:03 UTC
Re: bleeder resistors
Alan Marconett KM6VV
2002-02-13 18:22:27 UTC
Re: bleeder resistors
mariss92705
2002-02-13 18:29:02 UTC
Re: bleeder resistors
cadcamcenter
2002-02-13 19:34:09 UTC
Re: bleeder resistors