Still broken Bridgeport.
Posted by
kuchean
on 2002-02-16 17:59:54 UTC
I started the machine up again after manually cranking the table back
to a centered position to see if any limit switches might have been
tripped. Same old story!
1. hit numeric key 7 AXSDRV ENABLE.
2. Msg: Check for axis limit.
3. Sound of relay pull in/drop out.
4. Msg: Drive fault detected psi?,x,y,z Check Log.
What Log?
Also, the machine only has three axis not four, I don't think it ever
had a rotary table installed. All of this accompanied my much
blinking of LED indicators. Does anyone know how to interpert the
internal lightshow?
Bill Lubarsky
to a centered position to see if any limit switches might have been
tripped. Same old story!
1. hit numeric key 7 AXSDRV ENABLE.
2. Msg: Check for axis limit.
3. Sound of relay pull in/drop out.
4. Msg: Drive fault detected psi?,x,y,z Check Log.
What Log?
Also, the machine only has three axis not four, I don't think it ever
had a rotary table installed. All of this accompanied my much
blinking of LED indicators. Does anyone know how to interpert the
internal lightshow?
Bill Lubarsky
Discussion Thread
kuchean
2002-02-16 17:59:54 UTC
Still broken Bridgeport.
Raymond Heckert
2002-02-16 19:53:03 UTC
Re: [CAD_CAM_EDM_DRO] Still broken Bridgeport.