Re: [CAD_CAM_EDM_DRO] Feedrate overide
Posted by
Alan Marconett KM6VV
on 2002-02-19 12:20:02 UTC
Hi Jeff,
Do you mean percent override as opposed to just "up a few steps" in a
rate table? I can see why it would be easier just to move up a few
steps in my rate table. More complicated if a percentage must be
calculated.
Alan KM6VV
jeffdavis516 wrote:
Do you mean percent override as opposed to just "up a few steps" in a
rate table? I can see why it would be easier just to move up a few
steps in my rate table. More complicated if a percentage must be
calculated.
Alan KM6VV
jeffdavis516 wrote:
>
> Yes the percent adjustment is the way to go. I have been trying to
> get Yeager Automation to change CNCPro to add a percent overide. I
> don't get any responce anymore from him. I don't see that is would
> be a difficult thing to add.
>
> Jeff