Re: EMCO Tool Turret and CNCPRO
Posted by
ballendo
on 2002-02-28 03:39:44 UTC
Mark,
CncPRO has 5 "sensing inputs" (the status register of the p-port).
They are TYPICALLY used for homes(4 axes) and estop, but "could" be
otherwise assigned...
Also, the control register of the p-port can be used as inputs.
CncPRO deafaults these to I/O1-4; but doug may have allowed them to
be re-configured as inputs. I'd suggest asking him.
Hope this helps.
Ballendo
CncPRO has 5 "sensing inputs" (the status register of the p-port).
They are TYPICALLY used for homes(4 axes) and estop, but "could" be
otherwise assigned...
Also, the control register of the p-port can be used as inputs.
CncPRO deafaults these to I/O1-4; but doug may have allowed them to
be re-configured as inputs. I'd suggest asking him.
Hope this helps.
Ballendo
--- In CAD_CAM_EDM_DRO@y..., Mark Fraser <mfraser@h...> wrote:
> CNCPro has M03, 05, 07 .... >
<snip>
CNCPro has no sensing inputs, apparently, so feedback isn't an option.
<snip>
Discussion Thread
Mark Fraser
2002-02-27 10:57:04 UTC
EMCO Tool Turret and CNCPRO
Alan Marconett KM6VV
2002-02-27 14:51:28 UTC
Re: [CAD_CAM_EDM_DRO] EMCO Tool Turret and CNCPRO
ballendo
2002-02-28 03:39:44 UTC
Re: EMCO Tool Turret and CNCPRO