CNC retrofiter needed, OT I think
Posted by
Bruce Klawiter
on 2002-03-05 22:17:54 UTC
Hello All,
I'm at a loss. I have been trying to find a CNC retrofitter whom might have parts to an Anilam M controller they took off a machine they retrofitted. Someone out the has this controller sitting in there attic collecting dust I just need to find them. Any leads you can provide will be greatly appreciated.
Sorry if this is off OT.
Regards,
Bruce Klawiter
[Non-text portions of this message have been removed]
I'm at a loss. I have been trying to find a CNC retrofitter whom might have parts to an Anilam M controller they took off a machine they retrofitted. Someone out the has this controller sitting in there attic collecting dust I just need to find them. Any leads you can provide will be greatly appreciated.
Sorry if this is off OT.
Regards,
Bruce Klawiter
[Non-text portions of this message have been removed]
Discussion Thread
Bruce Klawiter
2002-03-05 22:17:54 UTC
CNC retrofiter needed, OT I think
Sven Peter
2002-03-06 05:53:57 UTC
Re: [CAD_CAM_EDM_DRO] CNC retrofiter needed, OT I think