CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Size of leadscrew clarification

on 2002-03-14 15:30:48 UTC
> >The purpose of this router is to cut model aircraft parts in balsa in
> >plywood, with 3/32 and 1/8" thick being most common. Based on my limited
> >experience doing the same with a Fadal VMC, about 20-25 ipm is the most
> >pratical for the 1/8" bits I'm using (I could experiment some more
> >though, but I don't think it'll go over 50ipm tops). Rapid travel is not
> >a issue. Thicker material can be done in multi passes, but would be rare.
> >The maximum size is 12"x 48".
>
> If you were milling or turning metal I would agree with your speed plans,
but for balsa, even plywood I think you are being too conservative.

John,

Gotta agree with Fred here, using a 3/32 bit I have been cutting .200 depth
in all kinds of wood at 120 IPM. I'm sure it would go a lot faster but
that's
plenty for me. For cheap bits that would work great for your purpose get
some of these circuit board drill bits at
http://tinkers-emporium.com/newpage31.htm
The picture shows a rasp like bit, but the picture of the bit in the marble
are the ones I am using. Best part is they are only about $10.00 for 50 of
them off ebay. If you break one, who cares. They are solid carbide and are
basicly
just a up spiral router bit with a small point on them. If you need a flat
bottom you can grind them flat. 1/16" gets into small corners. Here is an
auction he just had on ebay
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=1702160733

Email or call him and tell him you want a package of 50. Come in 1/16
and 3/32.

Just yesterday I was about to go to home depot and get a $30.00
diamond hole saw to cut faucet holes into some floor tile that I am putting
around my bathtub. I decided to try it on my router and cut 3 1.25" holes
into the tile with one of those bits using a spray bottle filled with water
for
coolant. Cutting balsa wood it ought to last years

Bill

Discussion Thread

John Thompson 2002-03-14 10:14:17 UTC Size of leadscrew clarification jeffswayze 2002-03-14 12:45:54 UTC Re: Size of leadscrew clarification IMService 2002-03-14 12:55:41 UTC Re: Size of leadscrew clarification William Scalione 2002-03-14 15:30:48 UTC Re: [CAD_CAM_EDM_DRO] Re: Size of leadscrew clarification RC 2002-03-14 16:46:49 UTC Re: [CAD_CAM_EDM_DRO] Re: Size of leadscrew clarification Raymond Heckert 2002-03-14 19:07:11 UTC Re: [CAD_CAM_EDM_DRO] Re: Size of leadscrew clarification RichD. 2002-03-14 19:32:38 UTC Re: [CAD_CAM_EDM_DRO] Re: Size of leadscrew clarification Chris L 2002-03-14 20:20:18 UTC Re: [CAD_CAM_EDM_DRO] Size of leadscrew clarification