Re: [CAD_CAM_EDM_DRO] Re : motor woes
Posted by
Steve Blackmore
on 2002-03-17 15:51:43 UTC
On Sat, 16 Mar 2002 07:28:05 +0000, you wrote:
you and Tim have said it looks like they are never gonna run fast.
I'm going to return them and if I go for unipolar probably get StepSyn
103H7123-0410.
Specs for these are 3.2V, 2A, 1.6Ohm, 3.8mH per phase.
I've now found a schematic for a simple chopper driver using
L297/L298's , I now may go with Bipolar type motors, if I can remember
how to use Protel to produce the PCB :)
Steve Blackmore
--
Pilot Consultancy Limited ***** Computer Consultants
Telephone 01744 752256 Mobile 07831 768478
Email: steve@... WWW: http://www.pilotltd.net
>> steve@...I'm tried them from 12-30V with current limiting, R/L but from what
>>
>> Has anybody used Astrosyn 8 wire T180 universal motors?
>>
>> Specs are as follows - 12v 0.6 amp/phase Res 20 Ohm/phase
>> Inductance 35mH/phase Torque 5.5Kg-cm.
>>
>> I can't get the damn things to run at anything above a crawl
>> without missing steps!!
>>
>> I'm running them in unipolar mode with a home built
>> controller based on UDN5804B's
>
>This is no surprise. 12V motors have to have a LOT of inductance.
>Runing them unipolar makes it even worse. What is your DC supply
>voltage? Is this an R/L drive or chopper type?
you and Tim have said it looks like they are never gonna run fast.
I'm going to return them and if I go for unipolar probably get StepSyn
103H7123-0410.
Specs for these are 3.2V, 2A, 1.6Ohm, 3.8mH per phase.
I've now found a schematic for a simple chopper driver using
L297/L298's , I now may go with Bipolar type motors, if I can remember
how to use Protel to produce the PCB :)
Steve Blackmore
--
Pilot Consultancy Limited ***** Computer Consultants
Telephone 01744 752256 Mobile 07831 768478
Email: steve@... WWW: http://www.pilotltd.net
Discussion Thread
Jon Elson
2002-03-17 12:36:27 UTC
Re : motor woes
Steve Blackmore
2002-03-17 15:51:43 UTC
Re: [CAD_CAM_EDM_DRO] Re : motor woes
n4onl
2002-03-17 21:08:14 UTC
Re: Re : motor woes
Jon Elson
2002-03-17 22:18:19 UTC
Re: [CAD_CAM_EDM_DRO] Re : motor woes
Steve Blackmore
2002-03-17 23:35:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: Re : motor woes