Gecko 320 Manual - is it the latest??
Posted by
onecooltoolfool
on 2002-03-24 08:39:01 UTC
I am testing my Gecko 320's right now and the board layout drawing
does not match the board. The board number under the large cap is
320 - 4.
The test points are not in the location on the dwg. There are two
loops at the "top" of the board. Are these the test point and ground?
Also what amperage should I fuse ahead of the drive? Motors are 5.5
amps max. Fast blow, or slow blow?
Help is appreciated.
Joe V.
does not match the board. The board number under the large cap is
320 - 4.
The test points are not in the location on the dwg. There are two
loops at the "top" of the board. Are these the test point and ground?
Also what amperage should I fuse ahead of the drive? Motors are 5.5
amps max. Fast blow, or slow blow?
Help is appreciated.
Joe V.