Re: KIT QUESTION??

Stan, All you need to get setup is linux, and the RT patch,
and EMC, and the STG card for a servo system. You should
make sure that all your software is compatible with each
other. Following is the site for installation instructions,

http://206.19.206.56/installemc.htm

Steve Carlisle

----------
From: STAN MCDONALD <smcdonal@...>
To: CAD_CAM_EDM_DRO@onelist.com
Subject: Re: [CAD_CAM_EDM_DRO] KIT QUESTION??
Date: Tuesday, December 14, 1999 4:25 PM

From: STAN MCDONALD <smcdonal@...>

Jon Elson wrote:
I hve linix ver 6 and have downloaded EMC. Other then the servos to go
board what else do I need and what comes in this kit?
Regards
Stan

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to http://www.ktmarketing.com/faq.html
bill,
List Manager