Re: 2 Axis Motion at Last, Plasma machine ???¿¿¿ Its possible ???
Posted by
ajv2803959
on 2002-04-03 01:24:14 UTC
Terry, glad to hear so good news.
I have been trying to set freqmod in order to get rapids of
4000mm/min or 160 IPM over a Pentium 333.
My max velocity with freqmod.o is 28 IPM without motors.
I have post question about this subject in this group and EMC group,
the response has been always, freqmod will need a power processor in
order to get higher rates.
Terry could you give any advice about your ini configuration ?
or better could you post your ini file in this group ?
TIA
--- In CAD_CAM_EDM_DRO@y..., "Toddy, Terry L CUBA" <tltoddy@o...>
wrote:
I have been trying to set freqmod in order to get rapids of
4000mm/min or 160 IPM over a Pentium 333.
My max velocity with freqmod.o is 28 IPM without motors.
I have post question about this subject in this group and EMC group,
the response has been always, freqmod will need a power processor in
order to get higher rates.
Terry could you give any advice about your ini configuration ?
or better could you post your ini file in this group ?
TIA
--- In CAD_CAM_EDM_DRO@y..., "Toddy, Terry L CUBA" <tltoddy@o...>
wrote:
> I finally have my 2 axis gantry moving. It's not cutting metal yetbut I
> thought this might be useful for those in the design stages of asimilar
> machine.motor on
>
> Driven by 1/5" pitch 3/8 wide timing belts, dual driven with single
> x600)
> x axis motor: 200 ozin SloSyn, 200 steps/rev
> y axis motor: 150 ozin SloSyn, 200 steps/rev
> x and y axis travel 1" per motor rev
> step resolution: .0005 with Gecko G201 10 microstep drives
> Max travel: x 125", y 52"
> Max velocity: 500 IPM (starts loosing steps at about 550, stalls at
> Software: EMC running freqmod on a 266 Pentium.< Snipped >
> The EMC is the BDI 2.04
>
> Thanks,
> Terry
Discussion Thread
Toddy, Terry L CUBA
2002-04-02 11:12:56 UTC
2 Axis Motion at Last, Plasma machine
Jon Elson
2002-04-02 21:55:06 UTC
Re: [CAD_CAM_EDM_DRO] 2 Axis Motion at Last, Plasma machine
ajv2803959
2002-04-03 01:24:14 UTC
Re: 2 Axis Motion at Last, Plasma machine ???¿¿¿ Its possible ???
Toddy, Terry L CUBA
2002-04-03 05:33:39 UTC
RE: [CAD_CAM_EDM_DRO] 2 Axis Motion at Last, Plasma machine
Jon Elson
2002-04-03 10:45:16 UTC
Re: [CAD_CAM_EDM_DRO] 2 Axis Motion at Last, Plasma machine
Toddy, Terry L CUBA
2002-04-03 10:50:16 UTC
RE: [CAD_CAM_EDM_DRO] 2 Axis Motion at Last, Plasma machine
morgtod
2002-04-03 13:47:50 UTC
Re: 2 Axis Motion at Last, Plasma machine