Desk Engrave
Posted by
Peter Smith
on 1999-12-20 12:04:33 UTC
To Dan Mauch 20/12/99 19.00
Dan
Many thanks for the info that Desk Engrave is now a freebee, I have tried it out and found it very good,
I have just managed to get some PBD 3517 Ericsson chips for the 5amp Board,
I should have time over the Christmas to try and blow these ones up as well, I have not had much time lately due to domestic improvements for the household forewoman, ( I painted the house 20 years ago when we moved in, but women are so demanding nowadays).
If anyone needs any PBD 3517 stepper motor drivers, I had to buy more than I needed, �2.50 each plus post U.K.
Many thanks to Paul Corner for his untiring advice, patience, and enthusiasm, and also many others from the list who have offered advice with my problems.
Best Wishes to all for 2000
Peter Smith
Dan
Many thanks for the info that Desk Engrave is now a freebee, I have tried it out and found it very good,
I have just managed to get some PBD 3517 Ericsson chips for the 5amp Board,
I should have time over the Christmas to try and blow these ones up as well, I have not had much time lately due to domestic improvements for the household forewoman, ( I painted the house 20 years ago when we moved in, but women are so demanding nowadays).
If anyone needs any PBD 3517 stepper motor drivers, I had to buy more than I needed, �2.50 each plus post U.K.
Many thanks to Paul Corner for his untiring advice, patience, and enthusiasm, and also many others from the list who have offered advice with my problems.
Best Wishes to all for 2000
Peter Smith