Re: Gecko 320 external pwr question
Posted by
mariss92705
on 2002-04-04 16:25:00 UTC
Bill,
Tie the +5vdc supply ground to "-ENCODER" (term. 6). You may use it
for the ERR/RES circuit. You may also use the internal +5vdc supply
so long as the encoder and external circuitry don't consume more than
50 mA.
Mariss
Tie the +5vdc supply ground to "-ENCODER" (term. 6). You may use it
for the ERR/RES circuit. You may also use the internal +5vdc supply
so long as the encoder and external circuitry don't consume more than
50 mA.
Mariss
--- In CAD_CAM_EDM_DRO@y..., wanliker@a... wrote:
> Mariss,
> When you are using an external 5 volt power supply with the G-320,
can you
> the same power supply for both the 5 volt referance and also the
err/res
> circuit? If so, where do you tie in the 5 volt minus?
> Is there any extra power available on the Encoder Supply, enough to
run the
> small err/res board that Alan is selling? <A
HREF="http://www.sfu.ca/~alan/gecko/err.html">Gecko Error Reset
Controller</A>
> thanks,
> bill
>
>
> [Non-text portions of this message have been removed]
Discussion Thread
wanliker@a...
2002-04-04 09:54:24 UTC
Gecko 320 external pwr question
mariss92705
2002-04-04 16:25:00 UTC
Re: Gecko 320 external pwr question