Re: 2 Axis Motion at Last, P machine INI FILE !!! HELP!!!
Posted by
ajv2803959
on 2002-04-05 02:44:15 UTC
Thanks for your reply.
Yesterday night, I was trying set period parameter in increments from
0.000020 until 0.000016
OK in 0.000020 interfaz and mouse run slowly but velocity don´t
improve.
In 0.000016 velocity don´t improve
In 0.000017 and 0.00016 system crash or reboot in Pentium 233 and
velocity don´t improve in Pentium 333
The error is the same always " minimilltaskintf.cc 969: Error on axis
0"
Have you more suggestion or parameter to try ?
Could you put a little section of your ini file in order to get some
light about this dark subject ?
EMC version 2.1.16 from Sourceforge and rtlinux 3.0
TIA
--- In CAD_CAM_EDM_DRO@y..., "Toddy, Terry L CUBA" <tltoddy@o...>
wrote:
Yesterday night, I was trying set period parameter in increments from
0.000020 until 0.000016
OK in 0.000020 interfaz and mouse run slowly but velocity don´t
improve.
In 0.000016 velocity don´t improve
In 0.000017 and 0.00016 system crash or reboot in Pentium 233 and
velocity don´t improve in Pentium 333
The error is the same always " minimilltaskintf.cc 969: Error on axis
0"
Have you more suggestion or parameter to try ?
Could you put a little section of your ini file in order to get some
light about this dark subject ?
EMC version 2.1.16 from Sourceforge and rtlinux 3.0
TIA
--- In CAD_CAM_EDM_DRO@y..., "Toddy, Terry L CUBA" <tltoddy@o...>
wrote:
> > Thank you for your reply:get
> > So I put the important section of my ini file. I can?t be able to
> > more than 4 KHZ pulse stream from EMC 16 Khz would be fine for me.doesn't lock
> > Take care about the units for me are millimeters not inches.
> > TIA
>
>
> You might try to decrease PERIOD to .000016, or smaller if it
> up your system.
>
> Terry
Discussion Thread
Toddy, Terry L CUBA
2002-04-04 08:07:50 UTC
RE: [CAD_CAM_EDM_DRO] Re: 2 Axis Motion at Last, P machine ??? IN I FILE please ???
ajv2803959
2002-04-05 02:44:15 UTC
Re: 2 Axis Motion at Last, P machine INI FILE !!! HELP!!!
Paul
2002-04-05 13:00:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: 2 Axis Motion at Last, P machine INI FILE !!! HELP!!!
ajv2803959
2002-04-08 00:48:43 UTC
Re: 2 Axis Motion at Last, P machine INI FILE !!! HELP!!!