Re: [CAD_CAM_EDM_DRO] Re: Servo and electronics selection
Posted by
batwings@i...
on 2002-04-06 14:23:47 UTC
At 03:57 PM 4/6/02 -0000, you wrote:
direction. Here is a perfectly good place to use a timing belt drive.
Regards, Hoyt
*ALL* posts with .htm attachments filtered to trash and *NOT READ*
Belfab CNC - http://www.freeyellow.com/members/belfab/belfab.html
Best MC Repair - http://www.freeyellow.com/members/batwings/best.html
Camping/Caving - http://www.freeyellow.com/members/batwings/caving.html
News Flash: Hamas vows revenge for the USS Liberty
>of the ball screws though. I will synchronize the two x axis ballMake sure your gear train has zero lash or they'll only be synched in one
>nuts by using a single geared driver.
direction. Here is a perfectly good place to use a timing belt drive.
Regards, Hoyt
*ALL* posts with .htm attachments filtered to trash and *NOT READ*
Belfab CNC - http://www.freeyellow.com/members/belfab/belfab.html
Best MC Repair - http://www.freeyellow.com/members/batwings/best.html
Camping/Caving - http://www.freeyellow.com/members/batwings/caving.html
News Flash: Hamas vows revenge for the USS Liberty
Discussion Thread
kdoney_63021
2002-04-05 19:08:49 UTC
Servo and electronics selection
Les Watts
2002-04-06 05:00:57 UTC
Re: [CAD_CAM_EDM_DRO] Servo and electronics selection
kdoney_63021
2002-04-06 07:57:27 UTC
Re: Servo and electronics selection
batwings@i...
2002-04-06 14:23:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: Servo and electronics selection