CAD CAM EDM DRO - Yahoo Group Archive

Re: The tape-O-matic...

Posted by Fred Smith
on 1999-12-21 04:57:41 UTC
----- Original Message -----
From: Brad Heuver <bheuver@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Monday, December 20, 1999 2:37 PM
Subject: [CAD_CAM_EDM_DRO] The tape-O-matic...


> From: "Brad Heuver" <bheuver@...>
>
> This weekend, instead of Christmas shopping, I hooked up the mill. That
> is, I hooked up the control cabinet to the machine. I have yet to
> actually put the 3 phase to the breaker. Here's the next question: The
> mill manual say that the incoming power must be phased correctly, or
> damage may result. I don't have a 'scope as yet, and don't know how to
> determine the phases of my convertor. Is it possible to do this without
> a 'scope?

The MSC catalog has a device called a 3 phase Rotation Tester. on page 3721
of the 98-99 catalog. I didn't check on-line, but it can probably be found
there with the correct description

$59.00 item number 06472211 This one appears to be all electronic. When my
brother the electrician hooked up my Fanuc 5T a few years back, he had one
that was actually a 3 phase motor with a little indicator for rotation.
Most industrial electricians carry one in their back pocket, otherwise the
money is well spent, compared to blowing out silicon, or even fuses. (My
Fanuc fuses are over $20.00 each for a some of them)


Best Regards,

Fred Smith
IMService

imserv@...
Phone: 248-486-3600 or 800-386-1670
Fax:248-486-3698

Discussion Thread

Brad Heuver 1999-12-20 11:37:52 UTC The tape-O-matic... Jeff Barlow 1999-12-20 13:09:18 UTC RE: The tape-O-matic... Charles VanLeeuwen 1999-12-20 15:54:18 UTC Re: The tape-O-matic... Jon Elson 1999-12-20 16:24:23 UTC Re: The tape-O-matic... Jeff Barlow 1999-12-20 21:38:20 UTC RE: The tape-O-matic... Fred Smith 1999-12-21 04:57:41 UTC Re: The tape-O-matic... Jon Elson 1999-12-21 12:46:01 UTC Re: The tape-O-matic... Igor 1999-12-21 13:56:31 UTC Re: The tape-O-matic... WAnliker@x... 1999-12-21 16:11:21 UTC Re: The tape-O-matic... Igor Valentic 1999-12-21 23:07:33 UTC Re: The tape-O-matic... George Potter 1999-12-22 21:17:27 UTC Re: The tape-O-matic...