Re: Gerber to G-code
Posted by
tonyjeffree
on 2002-04-14 23:48:15 UTC
--- In CAD_CAM_EDM_DRO@y..., Jon Elson <elson@p...> wrote:
isolation toolpath from a Gerber file, which is not quite the same. I
believe that the Eagle PCB layout software is capable of generating
such a toolpath from a PCB layout - there was a thread on this a
while back.
Regards,
Tony
> marble_h wrote:is
>
> > I think A while back there was some mention of Gerber to G-code
> > there a program that will do the change yet if so can some onepost
> > the web address .dialect, for sure,
>
> Gerber IS "G-code", officially RS-274D. It is a very wierd
> but it IS, in fact, G-code.Perhaps what he is looking for is the ability to generate a track
>
> Jon
isolation toolpath from a Gerber file, which is not quite the same. I
believe that the Eagle PCB layout software is capable of generating
such a toolpath from a PCB layout - there was a thread on this a
while back.
Regards,
Tony
Discussion Thread
Jon Elson
2002-04-14 23:11:43 UTC
Re: [CAD_CAM_EDM_DRO] Gerber to G-code
tonyjeffree
2002-04-14 23:48:15 UTC
Re: Gerber to G-code
waynegramlich
2002-04-14 23:49:12 UTC
Re: Gerber to G-code
marble_h
2002-04-15 08:19:23 UTC
Re: Gerber to G-code
imserv1
2002-04-15 09:39:32 UTC
Re: Gerber to G-code
Jon Elson
2002-04-15 10:29:43 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gerber to G-code
Alan Marconett KM6VV
2002-04-15 12:05:58 UTC
Re: Gerber to G-code
Cullins James
2002-04-15 13:48:49 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gerber to G-code