CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Gerber to G-code

Posted by Jon Elson
on 2002-04-15 10:29:43 UTC
tonyjeffree wrote:

> --- In CAD_CAM_EDM_DRO@y..., Jon Elson <elson@p...> wrote:
> > marble_h wrote:
> >
> > > I think A while back there was some mention of Gerber to G-code
> is
> > > there a program that will do the change yet if so can some one
> post
> > > the web address .
> >
> > Gerber IS "G-code", officially RS-274D. It is a very wierd
> dialect, for sure,
> > but it IS, in fact, G-code.
> >
> > Jon
>
> Perhaps what he is looking for is the ability to generate a track
> isolation toolpath from a Gerber file, which is not quite the same. I
> believe that the Eagle PCB layout software is capable of generating
> such a toolpath from a PCB layout - there was a thread on this a
> while back.

Well, this is totally different. It is not really a "conversion" but a complete
change in what information is in the Gerber file to produce something
quite different.

Yes, there are a couple programs that apparently do this.

Jon

Discussion Thread

Jon Elson 2002-04-14 23:11:43 UTC Re: [CAD_CAM_EDM_DRO] Gerber to G-code tonyjeffree 2002-04-14 23:48:15 UTC Re: Gerber to G-code waynegramlich 2002-04-14 23:49:12 UTC Re: Gerber to G-code marble_h 2002-04-15 08:19:23 UTC Re: Gerber to G-code imserv1 2002-04-15 09:39:32 UTC Re: Gerber to G-code Jon Elson 2002-04-15 10:29:43 UTC Re: [CAD_CAM_EDM_DRO] Re: Gerber to G-code Alan Marconett KM6VV 2002-04-15 12:05:58 UTC Re: Gerber to G-code Cullins James 2002-04-15 13:48:49 UTC Re: [CAD_CAM_EDM_DRO] Re: Gerber to G-code