CAD CAM EDM DRO - Yahoo Group Archive

Re: simple stepper power question.

Posted by mariss92705
on 2002-04-22 21:28:13 UTC
Bill,

I don't think there is a way short of using a dyno.

Mariss

--- In CAD_CAM_EDM_DRO@y..., wanliker@a... wrote:
> In a message dated 4/22/2002 10:12:34 AM Mountain Daylight Time,
> mariss92705@y... writes:
>
>
> > Use a pair of ferrite-core inductors in the place of the motor. I
use
> > two 600uH, 7A rated chokes. You can find these under the heading
> > of "hash chokes" in the Digikey catalog.
> >
>
> Mariss, is there something similar that can replace servos for
testing?
> Thanks,
> bill
>
>
> [Non-text portions of this message have been removed]

Discussion Thread

dave_ace_me 2002-04-18 05:13:12 UTC simple stepper power question. Dan Mauch 2002-04-18 07:21:09 UTC RE: [CAD_CAM_EDM_DRO] simple stepper power question. mariss92705 2002-04-18 09:06:32 UTC Re: simple stepper power question. Alan Marconett KM6VV 2002-04-18 11:48:40 UTC Re: [CAD_CAM_EDM_DRO] simple stepper power question. Alan Marconett KM6VV 2002-04-18 16:17:55 UTC Re: simple stepper power question. mariss92705 2002-04-18 20:36:25 UTC Re: simple stepper power question. ballendo 2002-04-19 09:35:10 UTC Re: simple stepper power question. Alan Marconett KM6VV 2002-04-19 16:18:28 UTC Re: simple stepper power question. Brian 2002-04-19 18:07:59 UTC Re: [CAD_CAM_EDM_DRO] Re: simple stepper power question. tonyjeffree 2002-04-21 23:28:14 UTC Re: simple stepper power question. mariss92705 2002-04-22 09:11:35 UTC Re: simple stepper power question. wanliker@a... 2002-04-22 09:34:49 UTC Re: [CAD_CAM_EDM_DRO] Re: simple stepper power question. tonyjeffree 2002-04-22 10:12:53 UTC Re: simple stepper power question. mariss92705 2002-04-22 21:28:13 UTC Re: simple stepper power question.