CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Re: BobCad 18

Posted by Dan Mauch
on 2002-04-27 12:27:04 UTC
I didn't see many comments so I d/led and install the demo copy. I
played with it for a while and came to the conclusion that there were
quite a few bugs in the program. For instance in the NC part I tried to
get it to generate the G code in the directions that I wanted and it
kept wanting to do it differently than what I wanted. In the draw
portion it did not seem like the trim/extend was working properly for
trimming a line to a circle.
Looks like it need some work.
Dan

Discussion Thread

zemenz2003 2002-03-19 07:59:45 UTC BobCad 18 stevenson_engineers 2002-03-19 12:26:12 UTC Re: BobCad 18 mart_wid 2002-03-19 19:24:18 UTC Re: BobCad 18 zemenz2003 2002-04-27 07:18:27 UTC BobCad 18 follicely_challenged 2002-04-27 11:00:44 UTC Re: BobCad 18 Dan Mauch 2002-04-27 12:27:04 UTC RE: [CAD_CAM_EDM_DRO] Re: BobCad 18 follicely_challenged 2002-04-28 00:12:05 UTC Re: BobCad 18 visionsto 2002-04-28 17:14:07 UTC Re: BobCad 18