Sinumeric
Posted by
Igor Valentic
on 1999-12-28 04:52:58 UTC
Does anybody know how to upload a G-code program in to an about 15 years old
Siemens Sinumeric mill controller? I saw 25-pin connector but there are no
marks on it. Parallel, serial, RS-232, RS-485 ??
Now we must all programs manual type in to it.
Many thanks,
Igor
Siemens Sinumeric mill controller? I saw 25-pin connector but there are no
marks on it. Parallel, serial, RS-232, RS-485 ??
Now we must all programs manual type in to it.
Many thanks,
Igor
Discussion Thread
Igor Valentic
1999-12-28 04:52:58 UTC
Sinumeric
Harrison, Doug
2000-01-05 18:25:40 UTC
RE: Sinumeric