Re: RF-45 mill almost done

Dan

Hey I was wondering how the rf45 projects were going. That's great.
Looking forward to the pictures.

You might try backing off the acceleration just a bit for the heaviest
axis. Generic.ini uses a 20 for that. A recent post from Matt suggested
much less. Try 5 and see if it stops jumping around so bad.

Ray


From: Dan Falck <dfalck@...>

>Subject: RF-45 mill almost done

<snip>

>So far, I've just cut a few things out of some scrap wood. It's time to
>put it to work and see how things really work. I noticed that when it was
>doing rapid moves the welded up frame of the machine stand seemed to shake
>a bit. I'll have to take care of this with sand bags in the base and by
>bolting it to the floor. I don't have to run the table really fast for the
>small parts that I make, but it's always fun to push it hard just to see
>how far it will go (without tipping over :>). If anyone's interested in
>seeing this machine, I'll take some photos and post them soon. ( on an ftp
>site )