Re: stepper Motor Controller
Posted by
SNTLewis@a...
on 2000-01-02 12:24:47 UTC
In a message dated 1/2/00 11:53:07 AM Eastern Standard Time, av1a@...
writes:
<< I want to know is there is any schematic (circuit) and documentation
available
for stepper motor contoller which connects with Parallel port . beacuse i
want
to make the stepper amplifier myself.
controller hook-ups, e.g. bipolar, unipolar, L/R, chopper, etc. A good place
to start is at the following BBS - "www.eio.com\public\stepper" Of
particular interest is the Ericsson and SGS-Thomson Websites. Sorry but I
can't remember then and I don't have them marked. Check out posts by Kevin
Carrol as his design used the Ericsson chips. I used the SGS-Thomson set.
Kevin has since died but I and others have his board design.
Hope this helps...
In His Service+
Stan Lewis
writes:
<< I want to know is there is any schematic (circuit) and documentation
available
for stepper motor contoller which connects with Parallel port . beacuse i
want
to make the stepper amplifier myself.
>>There is scads of this information available on several different types of
controller hook-ups, e.g. bipolar, unipolar, L/R, chopper, etc. A good place
to start is at the following BBS - "www.eio.com\public\stepper" Of
particular interest is the Ericsson and SGS-Thomson Websites. Sorry but I
can't remember then and I don't have them marked. Check out posts by Kevin
Carrol as his design used the Ericsson chips. I used the SGS-Thomson set.
Kevin has since died but I and others have his board design.
Hope this helps...
In His Service+
Stan Lewis
Discussion Thread
av1a@x...
2000-01-02 08:53:06 UTC
stepper Motor Controller
SNTLewis@a...
2000-01-02 12:24:47 UTC
Re: stepper Motor Controller
Steve Carlisle
2000-01-02 14:01:09 UTC
Re: stepper Motor Controller