CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Where to learn?

Posted by RichD
on 2002-05-19 20:02:47 UTC
Fernando,
I found this subject explained at the FAQ address listed below.
There are many links to many CNC sites for lots of info.
RichD
Again:
Addresses:
FAQ: http://www.ktmarketing.com/faq.html

ferlopag wrote:
>
> Hi:
>
> I've been a member of the group for a while but this is the first
> time I post sometihing (I've spend this time reading the past
> messages).
>
> I have a question for you Where in the internet can I found some
> material to learn about G and M codes?
>
> Thanks in advance,
>
> Fernando, from Mexico City
>
> Addresses:
> ************FAQ: http://www.ktmarketing.com/faq.html**************
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this as a sister site to the CCED group, as many of the same members are there, for OT subjects, that are not allowed on the CCED list.
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner

Discussion Thread

ferlopag 2002-05-19 19:54:33 UTC Where to learn? RichD 2002-05-19 20:02:47 UTC Re: [CAD_CAM_EDM_DRO] Where to learn? webstercnc 2002-05-22 10:09:30 UTC Re: Where to learn?