Re: [CAD_CAM_EDM_DRO] emc bdi

Patrick,

I think Yahoo uses the first part of your email for your user name
If you get your mail at patrick@... try "patrick" for your
user name. Then you can click the "forgot your password" button
and they will email it to you.

Did yo put the negative sign in front of the "input scale" parameter
under the axis 2 heading? That should change the direction, it
always has for me. I don't think putting it in the "output scale" will
make any difference with steppermod.

Bill

> I just thought this might be useful somehow - when I
> tried to run steppermod with tkemc I got the same
> system slow-down that a few people have been talking
> about. When I switched to steppermod with Xemc as the
> gui, the problem went away. Could this be a bug in
> tkemc or is that gui just not compatible with
> steppermod? Everything runs very well with steppermod
> and Xemc. I also had the issue with my z-axis going the
> wrong way and I tried putting a negative sign in front
> of the scale parameter in the .ini file. This produced
> no difference whatsoever. Should that have worked? I
> would rather change the motion direction using the .ini
> file if I could for reasons I'll get into in a moment.
> Is it possible to make this alteration in the software?
> The reason I would prefer not to mess with the wiring
> on my Geckos to change directions is that my mill (emco
> maier f1) is both a vertical and horizontal mill. I
> plan to just switch the wires for my x and z axes when
> I rotate my spindle into horizontal mode. If I have
> switched the wires on the Gecko for the typically
> vertical configuration, then I fear that the direction
> will be backwards when I use the horizontal
> configuration. Right? Any suggestions?
> Pat Huss
>
>
> PS. I just tried to send this using the exact same
> email address I have used to correspond with this group
> for years. I got the message back because this account
> is apparently not my "registered" email account with
> this mailing list and I'm not allowed to use any other
> account to send to this group? Being as I have done it
> this way for years, I must say this is incredibly
> annoying. I haven't logged on to yahoo groups since the
> day I signed up for this list on yahoo, and I have no
> recollection whatsoever what my account name or
> password are, information I need to change the settings
> for my "acceptable" email account. What gives?
>