Re: help again

You can't get % volts from the parallel port. Use a spare drive
connector to get the 5 volts. Yes, you can connect all of the drives
to the same 5 volt supply.

--- In CAD_CAM_EDM_DRO@y..., "markpowerplus" <mabw@b...> wrote:
> Ah hi everyone!
> Dumbo question time again, about to rig up these gecko 201's and
the
> white paper says to use 5 volt from the pulse generator(computer)
so
> do i get this from one of the pins from the db25 cable and if so
> which one? and do I need three seperate ones ,one for each drive?
or
> can I loop just one to each drive? I know not to do that with
power
> supply for the motors!
> thanking you all in advance
> kindest regards
> Mark