CAD CAM EDM DRO - Yahoo Group Archive

Re: help again

Posted by rsgoldner
on 2002-05-28 14:56:32 UTC
Sorry, that should read 5 not %.

--- In CAD_CAM_EDM_DRO@y..., "rsgoldner" <rgoldner@i...> wrote:
> You can't get % volts from the parallel port. Use a spare drive
> connector to get the 5 volts. Yes, you can connect all of the
drives
> to the same 5 volt supply.
>
> --- In CAD_CAM_EDM_DRO@y..., "markpowerplus" <mabw@b...> wrote:
> > Ah hi everyone!
> > Dumbo question time again, about to rig up these gecko 201's and
> the
> > white paper says to use 5 volt from the pulse generator
(computer)
> so
> > do i get this from one of the pins from the db25 cable and if so
> > which one? and do I need three seperate ones ,one for each
drive?
> or
> > can I loop just one to each drive? I know not to do that with
> power
> > supply for the motors!
> > thanking you all in advance
> > kindest regards
> > Mark

Discussion Thread

markpowerplus 2002-05-28 14:35:14 UTC help again rsgoldner 2002-05-28 14:54:44 UTC Re: help again rsgoldner 2002-05-28 14:56:32 UTC Re: help again