RE: [CAD_CAM_EDM_DRO] Re: DeskWinNC....any users?

Definitely not the Camtronis drivers. They're essentially three separate
single axis drivers which happen to be mounted on the same PC board, use the
same power supplies, and use the same connector to interface to the
computer.

More likely, it's the computer speed or the G-Code interpreter, with my bet
being on the computer speed. If there were a problem with the G-Code
interpreter, I'd expect that you'd have problems running correctly at any
speed.

-- Jerry

|Here I'm not sure where the problems are: either the camtronics
|controller cannot run all three axis that fast, or my computer is
|not fast enough( celeron 400)or there is something with deskwinnc
|that needs to be fixed.