Fanuc, Cables and Windows
Posted by
steveggca
on 2002-06-11 03:34:51 UTC
The standard rs232 cable for Fanuc is as follows
Fanuc end: 25 pin connector jumper pin 4-5 jumper pin 6-8-20
Fanuc to PC connection. 25 pin PC: fanuc pin 2-PC pin 3
fanuc pin 3-PC pin 3
fanuc pin 7-pc pin 7
fanuc pin 1-cable shield
Fanuc to PC connection 9 pin PC fanuc pin 7-PC pin 5
Other pins the same
How to set windows terminal or Hyperterminal to work with fanuc
http://www.amada.com/support/turrets/general/FANUC%2018P%
20Communications%20rev3.pdf
you can also use procomm for dos (if you can find a copy) if you are
still in the Dos world.
All CAM packages have a comm module (or they should) so all that is
needed is the cable.
This cable is good for up to about 200' but at lower baud rates.
Fanuc end: 25 pin connector jumper pin 4-5 jumper pin 6-8-20
Fanuc to PC connection. 25 pin PC: fanuc pin 2-PC pin 3
fanuc pin 3-PC pin 3
fanuc pin 7-pc pin 7
fanuc pin 1-cable shield
Fanuc to PC connection 9 pin PC fanuc pin 7-PC pin 5
Other pins the same
How to set windows terminal or Hyperterminal to work with fanuc
http://www.amada.com/support/turrets/general/FANUC%2018P%
20Communications%20rev3.pdf
you can also use procomm for dos (if you can find a copy) if you are
still in the Dos world.
All CAM packages have a comm module (or they should) so all that is
needed is the cable.
This cable is good for up to about 200' but at lower baud rates.
Discussion Thread
steveggca
2002-06-11 03:34:51 UTC
Fanuc, Cables and Windows
steveggca
2002-06-11 03:43:00 UTC
Re: Fanuc, Cables and Windows