Re: Fanuc, Cables and Windows

It should read fanuc pin 3-PC pin 2 of course

>- In CAD_CAM_EDM_DRO@y..., "steveggca" <steveggca@y...> wrote:
> The standard rs232 cable for Fanuc is as follows
> Fanuc end: 25 pin connector jumper pin 4-5 jumper pin 6-8-20
>
> Fanuc to PC connection. 25 pin PC: fanuc pin 2-PC pin 3
> fanuc pin 3-PC pin 2
> fanuc pin 7-pc pin 7
> fanuc pin 1-cable shield
> Fanuc to PC connection 9 pin PC fanuc pin 7-PC pin 5
> Other pins the same
>
> How to set windows terminal or Hyperterminal to work with fanuc
> http://www.amada.com/support/turrets/general/FANUC%2018P%
> 20Communications%20rev3.pdf
>
> you can also use procomm for dos (if you can find a copy) if you

are

> still in the Dos world.
> All CAM packages have a comm module (or they should) so all that

is

> needed is the cable.
>
> This cable is good for up to about 200' but at lower baud rates.