+5 VDC @ Gecko's
Posted by
jfglass2001
on 2002-06-17 15:48:51 UTC
Hi all,
Quick question:
I am wiring up my Gecko's and one of the terminals has me stumped.
It says : +5VDC. I know that 5 volt is for the circuit board, right?
The question is: Where do I get it off of? My power supply (courtesy
of MicroKinetics) has a 5 vdc lead coming off of it. I am running
Master5, does my breakout board carry 5 volts? If so, what pin?
Thanks in advance,
Seth
I am not an electrician, just a machinist. ;)
Quick question:
I am wiring up my Gecko's and one of the terminals has me stumped.
It says : +5VDC. I know that 5 volt is for the circuit board, right?
The question is: Where do I get it off of? My power supply (courtesy
of MicroKinetics) has a 5 vdc lead coming off of it. I am running
Master5, does my breakout board carry 5 volts? If so, what pin?
Thanks in advance,
Seth
I am not an electrician, just a machinist. ;)
Discussion Thread
jfglass2001
2002-06-17 15:48:51 UTC
+5 VDC @ Gecko's
walterv
2002-06-17 16:21:56 UTC
Re: [CAD_CAM_EDM_DRO] +5 VDC @ Gecko's