Re: [CAD_CAM_EDM_DRO] +5 VDC @ Gecko's
Posted by
walterv
on 2002-06-17 16:21:56 UTC
Im hooking up the same setup and I took the 5Volts off the computer, if you
have a sound card the joy stick connector has 5V else its the red wire on a
drive power cord inside, just one wire needed no ground needed,
If your using master5 and have it setup id like to know how to set it up
also,
have a sound card the joy stick connector has 5V else its the red wire on a
drive power cord inside, just one wire needed no ground needed,
If your using master5 and have it setup id like to know how to set it up
also,
----- Original Message -----
From: "jfglass2001" <jfglass2001@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, June 17, 2002 3:48 PM
Subject: [CAD_CAM_EDM_DRO] +5 VDC @ Gecko's
> Hi all,
>
> Quick question:
>
> I am wiring up my Gecko's and one of the terminals has me stumped.
> It says : +5VDC. I know that 5 volt is for the circuit board, right?
> The question is: Where do I get it off of? My power supply (courtesy
> of MicroKinetics) has a 5 vdc lead coming off of it. I am running
> Master5, does my breakout board carry 5 volts? If so, what pin?
>
>
>
>
> Thanks in advance,
> Seth
>
>
>
> I am not an electrician, just a machinist. ;)
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this as a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
>
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
Discussion Thread
jfglass2001
2002-06-17 15:48:51 UTC
+5 VDC @ Gecko's
walterv
2002-06-17 16:21:56 UTC
Re: [CAD_CAM_EDM_DRO] +5 VDC @ Gecko's