FS: Bridgeport BOSS Series 1 Ahha! conversion - Seattle
Posted by
stephenmtate
on 2002-06-25 20:33:36 UTC
Hi Guys,
I hav'nt been around for a while but I looking at start a new
project. I want to make a CNC Plasma Cutter. Any suggestion about
where to start. I've done two previous conversions the last on being
my BOSS which I converted to Ahha!
I did a real nice job, I stripped off all the old electronics and
the two big cabinets and custom fabricated an aluminum box that I put
on the back just big enough to accomidate the ahha controller ond
necessary relays. I even rebuild the ball screws to get rig of any
back lash. If you like I can post some pictures. I've been making so
real nice parts too.
Anyway, I'm looking at selling now as I need to finance my next
project. I'm asking $7,500. Ya, I know that seems high but there
hard to find in Seattle. I paid a lot for the base machine.
Steve
PS its a 200 kwik switch spindle.
I hav'nt been around for a while but I looking at start a new
project. I want to make a CNC Plasma Cutter. Any suggestion about
where to start. I've done two previous conversions the last on being
my BOSS which I converted to Ahha!
I did a real nice job, I stripped off all the old electronics and
the two big cabinets and custom fabricated an aluminum box that I put
on the back just big enough to accomidate the ahha controller ond
necessary relays. I even rebuild the ball screws to get rig of any
back lash. If you like I can post some pictures. I've been making so
real nice parts too.
Anyway, I'm looking at selling now as I need to finance my next
project. I'm asking $7,500. Ya, I know that seems high but there
hard to find in Seattle. I paid a lot for the base machine.
Steve
PS its a 200 kwik switch spindle.