RE: [CAD_CAM_EDM_DRO] CAM Software and Hardware

I just looked at the acumotion site, and if those motors are 144 ozin then
they should do the job. However I am concerned about the 11 volt power
supply. You really should have a power supply that puts out at least 36
volts for good performance, 48 volts is preferable. You need 20 times the
rated voltage for the best performance. I run my system on 38 volts and get
acceptable performance but could really use 70 volts or better.

The Sherline is definitely capable of much better performance than you are
getting. I would assume that part of the grand you paid for the system
includes support from Accumotion!

John Guenther
Sterling, Virginia

> -----Original Message-----
> From: MARK & DAWN BROWN [mailto:bmdawn@...]
> Sent: Friday, June 28, 2002 20:49I
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: Re: [CAD_CAM_EDM_DRO] CAM Software and Hardware
>
>
> Understood. I didn't want to go online and blast a hardware/software
> manufacturer when perhaps it was a configuration issue. The is the kit
> Acumotion sells. http://www.acumotion.com
> I have been doing some research and believe I have alot of the answers to
> the software issues. Now I just need possibly better/stronger
> steppers.
> ----- Original Message -----
> From: "Jon Elson" <elson@...>
> To: <CAD_CAM_EDM_DRO@yahoogroups.com>
> Sent: Thursday, June 27, 2002 11:44 PM
> Subject: Re: [CAD_CAM_EDM_DRO] CAM Software and Hardware
>

<<SNIP>>