Re: [CAD_CAM_EDM_DRO] Basic Stamp + Encoder
Posted by
James Owens
on 2002-06-30 04:53:40 UTC
Hi,
The pricing below takes this out of the experimenters/have a go category.
If a stamp was necessary, and I believe it would be too slow, one way around
the problem may be to take some load off it by using some ancillary chips.
e.g.. feed the encoder output into an LS7084 and have this sort the
direction and count signals, into 4516 then into a stamp just to do the
calculation and output to an LCD display. Total cost about $30. I would
prefer a PIC based system as they have more than enough speed to cope with
all of the process.
| Analog Devices has a resolver to digital chip set that might be
interesting.
| It outputs position in digital format plus quadrature encoder signals. One
| chip provides the reference signal, the other one channel of data. The
| reference signal could drive multiple resolvers. Last time I looked IIRC
| three chips totaled around $125 US.
Regards,
Terry
The pricing below takes this out of the experimenters/have a go category.
If a stamp was necessary, and I believe it would be too slow, one way around
the problem may be to take some load off it by using some ancillary chips.
e.g.. feed the encoder output into an LS7084 and have this sort the
direction and count signals, into 4516 then into a stamp just to do the
calculation and output to an LCD display. Total cost about $30. I would
prefer a PIC based system as they have more than enough speed to cope with
all of the process.
| Analog Devices has a resolver to digital chip set that might be
interesting.
| It outputs position in digital format plus quadrature encoder signals. One
| chip provides the reference signal, the other one channel of data. The
| reference signal could drive multiple resolvers. Last time I looked IIRC
| three chips totaled around $125 US.
Regards,
Terry
Discussion Thread
wscalione
2002-06-29 15:02:17 UTC
Basic Stamp + Encoder
James Owens
2002-06-29 16:37:00 UTC
Re: [CAD_CAM_EDM_DRO] Basic Stamp + Encoder
turbulatordude
2002-06-29 18:28:30 UTC
Re: Basic Stamp + Encoder
Keith Bowers
2002-06-29 18:45:54 UTC
Re: [CAD_CAM_EDM_DRO] Basic Stamp + Encoder
David Micklethwaite
2002-06-30 04:49:45 UTC
Re: [CAD_CAM_EDM_DRO] Basic Stamp + Encoder
James Owens
2002-06-30 04:53:40 UTC
Re: [CAD_CAM_EDM_DRO] Basic Stamp + Encoder
James Owens
2002-06-30 05:05:04 UTC
Re: [CAD_CAM_EDM_DRO] Basic Stamp + Encoder
David Micklethwaite
2002-06-30 16:49:31 UTC
Re: [CAD_CAM_EDM_DRO] Basic Stamp + Encoder
James Owens
2002-06-30 17:19:48 UTC
Re: [CAD_CAM_EDM_DRO] Basic Stamp + Encoder
mayfieldtm
2002-07-01 10:13:37 UTC
RE: Basic Stamp + Encoder
timgoldstein
2002-07-01 10:15:41 UTC
Re: Basic Stamp + Encoder
Ian W. Wright
2002-07-01 11:08:06 UTC
Re: [CAD_CAM_EDM_DRO] RE: Basic Stamp + Encoder
serv4volley
2002-07-01 11:30:38 UTC
Re: Basic Stamp + Encoder