CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Gekkos

Posted by Jon Elson
on 2002-07-02 21:13:52 UTC
Gene wrote:

> I just changed my motherboard and everything works fine with BDI and
> Gecko 201. But when I turn the power off to the computer one axis creeps
> slowly With no way to stop it except turn the power off. is this normal?

You obviously don't have your e-stop circuits hooked up. You should have
something that disables the Gecko drives when the computer is powered down.

Jon

Discussion Thread

Gene 2002-07-02 17:16:36 UTC Gekkos Jon Elson 2002-07-02 21:13:52 UTC Re: [CAD_CAM_EDM_DRO] Gekkos Joll503@A... 2002-07-02 22:26:18 UTC Re: [CAD_CAM_EDM_DRO] Gekkos Gene 2002-07-03 00:18:50 UTC Re: [CAD_CAM_EDM_DRO] Gekkos turbulatordude 2002-07-03 06:46:44 UTC BDI, ( was Re: Gekkos Ray Henry 2002-07-03 07:27:33 UTC Re: Re: Gekkos Gene 2002-07-03 08:08:23 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: Gekkos Ray Henry 2002-07-03 18:11:40 UTC Re: Re: Re: Re: Gekkos Jon Elson 2002-07-03 22:44:23 UTC Re: [CAD_CAM_EDM_DRO] Gekkos Jon Elson 2002-07-03 22:57:45 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: Gekkos